Rank: Advanced Member Groups: Member
Joined: 8/10/2002 Posts: 1,588 Location: England
|
Robert Heuston wrote:Im looking at getting this, out of curiousity how many rivits do you have to drill out to take the luffer off? There are two which have to be drilled, and two smaller friction rivets which have to be pushed out. Not too much of a job really - see below - but obviously it is at the collector's risk. Ian http://www.CranesEtc.co.ukhttp://www.Twitter.com/CranesEtchttp://www.YouTube.com/CranesEtcTVCranes Etc on Facebook
|
Rank: Advanced Member Groups: Member
Joined: 6/23/2010 Posts: 1,734 Location: Hunter Valley
|
Thank you Ian, my plan was to drill out the rivit then drill the hole a little larger and use small nuts and bolts if i decided to et the luffer on. So a table drill would be best to do it on?
|