|
Rank: Member Groups: Member
Joined: 9/5/2021 Posts: 20 Location: Las Palmas, Islas Canarias, España.
|
Good morning! After many tests and configuration changes I have managed to obtain my flexible material tires in scale with an acceptable result :d/ , the only thing that I have to polish the inner face of the tire to remove the marks of the supports...
|
|
Rank: Advanced Member Groups: Member
Joined: 9/12/2012 Posts: 484 Location: San Diego, California
|
Did you cast these yourself or were they purchased?
|
|
Rank: Advanced Member Groups: Member
Joined: 8/27/2002 Posts: 4,827 Location: New Jersey
|
What model machines will these tires fit?
|
|
Rank: Member Groups: Member
Joined: 9/5/2021 Posts: 20 Location: Las Palmas, Islas Canarias, España.
|
Dex wrote:Did you cast these yourself or were they purchased? Hi Dex, I do. Having a picture of the tire track and the measurements or scale, I can do it, even if it's a custom tire track.
|
|
Rank: Member Groups: Member
Joined: 9/5/2021 Posts: 20 Location: Las Palmas, Islas Canarias, España.
|
RMS Models wrote:What model machines will these tires fit?
Hi RMS Models, the four that are the same, it is an order for a CAT 980C scale 1:50. The other three are test models with different tire tracks.
|
|
Rank: Advanced Member Groups: Member
Joined: 3/4/2003 Posts: 1,372 Location: Colorado
|
Will you be marketing these? Thank you.
Still Plays with Toys
|
|
Rank: Member Groups: Member
Joined: 9/5/2021 Posts: 20 Location: Las Palmas, Islas Canarias, España.
|
Gd10r wrote:Will you be marketing these? Thank you. Hi Gd10r!, yes... I can do for sale but little by little because my machine can only do two at a time when the tire diameter is less than 40mm. and the manufacturing time is 2 hours.
|
|
Rank: Advanced Member Groups: Member
Joined: 9/12/2012 Posts: 484 Location: San Diego, California
|
Are you 3d printing these or casting them in a mold?
|
|
Rank: Member Groups: Member
Joined: 9/5/2021 Posts: 20 Location: Las Palmas, Islas Canarias, España.
|
Dex wrote:Are you 3d printing these or casting them in a mold? Hi Dex! It is by 3D printing with flexible resin, that is why in manufacturing timeā¦ if you tried to reduce the time, this resin offers a lot of resistance and the stepper motor loses steps. You could increase the layer thickness which is now 0.05mm. but I don't know if it would lose quality... I would have to try...
|
|
Guest |